How To Cut Down On Chain Garage Door Noise

Are you unwell and worn out of coming residence from work everyday and listening to your chain storage door groan and whine? Chain storage doors are naturally a bit noisy, however, will also be affected by a series of issues that make them even louder. Fortunately, there are several easy upkeep methods you can use to decrease garage door noise. You may check the best bench vise in the market. 

Step One: Lubricate the Chains and Rails

Poorly lubricated chains and rails are the most common causes of noisy chain garage doors. Lubricating the chains and rails is a relatively simple process that involves the following steps:

Closing the garage door and unplugging the garage door opener

Cleaning the dried up grease from the chain with a rag and add a new coating of grease to the chain with a fresh rag.

Spraying the chain with silicone spray.

Repeating this entire procedure for both door chains and plugging the opener back in.

This step is usually enough to cure most of your garage door noise. However, if it is still making strange noises, move on to the next step.

Step Two: Tightening Loose Hardware

There are so many items on a chain garage door that have the potential to get loose and cause a racket. These potentially loose chain garage items include:

  • Mounting brackets attaching the door to the wall.
  • Chain tracks.
  • Fasteners holding the chain in place.
  • Garage door chains.
  • Screws and bolts.

Pay special attention to the tracks and chains. These items are the most active in your door and thus more likely to get loose. Tighten any loose item with the proper screwdriver or wrench.

Thankfully, this step is usually enough to cure most noise. However, if your door is still screaming for bloody mercy, it’s time to move on to the next step.

Step Three: Replacing Hinges

Broken or worn down garage door hinges are really easy to ignore, but have the potential to make a lot of noise. Thankfully, replacing garage door hinges is simple. Replacing a hinge requires:

Lowering the garage door and setting up your ladder, if the hinge is too high to reach.

Removing the bolts holding your hinge to the door and saving them for the replacement hinge.

Sliding the hinge onto the roller and lining up the new hinge bolt holes with the hinge holes in the door.

Placing a bolt in each hinge hole and tightening each slowly and evenly until each bolt is flush with the surface of the hinge.

If your garage door is still too noisy, it’s time to check for pesky animal invaders.

Step Four: Check for Animals

Garage’s often suffer from a wide range of animal infestations, from birds, bees, skunks, cats and even rats. These animals contribute to chain door noise by nesting in the door’s mechanics.

Check these areas of your garage door for animal nests:

  • Atop the opener control panel.
  • In the panel folds.
  • Near the chain holder.

Removing inspects from your garage is as simple as spraying the infested areas with a pest control product. Unfortunately, you should never try to handle a wild or feral animal without the help of an animal control expert. Cats, skunks and rats carry a wide variety of diseases, including rabies.

If your garage door is still making ungodly high levels of noise, it may be time to call a garage door repair expert.

You May Also Like to Read:

Top